SWAG Off Road "Tube" Dimple Die Combination Sets

Description

SWAG "Tube" Dimple Die Sets
Whether it be for cosmetic applications or looking to improve the rigidity of plate steel the SWAG dimple dies are capable of dimpling 3/16" steel.
Made in the USA out of domestic steel  these dimple dies come with a life time warranty, you split them in half and we will replace them free of charge, it's that simple.   These dimple dies are CNC machined out of 4140 quenched and tempered chrome moly steel that has a tensile strength of 150,000 KSI.  Each dimple die has a through hole drilled into both the male and female dies so they can be used in a few different ways.
The first method is they can be used in any H frame hydraulic press where the material you are dimpling is small enough to fit between the vertical frame rails of the press.  Simply drill the appropriate size hole using an industry stand hole saw, then insert the male and female dies to the correct orientation then using the hydraulic cylinder, press the dimple dies down to flare the metal.
The second method is they can be bolted together using a standard off the shelf grade 8 fasteners 3/4" dia bolt or 7/16" dia bolt depending upon which dimple die size you have.  This method is ideal for large pieces of metal that are too large to fit in a H frame style press, dimpling on a vehicle or dimpling after the fact....."Hey we should have put a dimple die there"...Well now you can with the through hole design that is standard on every die set we produce.
The third method is they can be pressed together using a 10 Ton Hydraulic Knockout Punch Driver. Not sure what one is, check out Ebay or Harbor Freight, they sell for ~ 0.00 shipped to your door step and they are a real time saver if you are dimpling a large number of items or hard to reach dimple die locations, it included a manual hand pump to apply hydraulic pressure to the punch set.
The knock out punch set is a quality product as we have dimpled thousands of holes for years using this set up.  We even attached a Harbor freight foot operated air/hydraulic foot pump
Central Hydraulics - item #98318 for even faster semi-production speed dimpling.
Are looking to dimple dies holes that are close together but not have them overlap, if so you you need to position them so the outside diameter will not interfere with the other dimple died holes.
The over all outside diameter of the dimple dies are as follows;
.
500"
dimple die OD =
1.20"
.750" dimple die OD = 1.45"
1.00"
dimple die OD = 1.95"
1.25
"
dimple die OD = 2.40"
1.50"
dimple die OD = 2.70"
1.75"
dimple die OD = 3.17"
2.00"
dimple die OD = 3.40"
2.50" dimple die OD = 4.20"
The Knock Out Punch Set can be purchased directly from HF for
.
The 10,000 PSI Air Hydraulic Pump
can be purchased directly from HF for 0
.
Please Note:  We do not sell the hydraulic punch driver and or the Air/Hydraulic foot switch, they are shown in the image gallery for reference only.  At this time we are not going to split up our knock out punches individually.
The thread pitch on the knock out punch dies are a 3/4"-16 TPI.
This item ships out using USPS priority mail, please provide a valid USPS shipping address.
CLICK HERE FOR YOUTUBE DEMO VIDEO AND INSTRUCTIONS
Additional details can be found on our website: swagoffroad.com
website linking