-40%

Loctite 3450 EA&B HYSOL two component epoxy adhesive which cures rapidly 25 ml

€ 4

Availability: 19 in stock
  • Brand: Loctite
  • Warranty: Yes
  • UPC: 9002010372864
  • Condition: New
  • Manufacturer Part Number: 3450 25g

    Description

    LOCTITE
    3450
    Product description:
    Loctite Hysol 3450 is a two component epoxy adhesive which cures rapidly at room temperature after mixing. It is a metal bonding adhesive which develops high strength.
    TYPICAL APPLICATIONS
    The gap filling properties make this adhesive system suitable for rough or poorly fitting surfaces made from metal, ceramic, wood or rigid plastics. Applications include bonding aluminium
    window frames and GRP panels.
    Directions for use
    1. For best performance surfaces for bonding should be clean, dry and free of grease. For high strength structural bonds, special surface treatments can increase the bond strength and
    durability .
    2. To use, resin and hardener must be blended. Product can be applied directly from dual cartridges by dispensing through the mixer head supplied. Discard the first 3-5 cm of bead
    dispensed. Using bulk containers, mix thoroughly by weight or volume in the proportions specified in Properties of Uncured Material section. For hand mixing , weigh or measure out the
    desired amount of resin and hardener and mix thoroughly. Mix approximately 15 seconds after uniform colour is obtained.
    3. Do not mix quantities greater than 4kg as excessive heat build-up can occur. Mixing smaller quantities will minimise the heat build-up.
    4. Apply the adhesive as quickly as possible after mixing to one surface to be joined. For maximum bond strength apply adhesive evenly to both surfaces. Parts should be assembled
    immediately after mixed adhesive has been applied. 5. Working life of the mixed adhesive is 4-6 minutes at 25°C. Higher temperature and larger quantities will shorten this
    working time.
    6. Keep the assembled parts from moving during cure. The joint should be allowed to develop full strength before subjecting to any service loads.
    7. Excess uncured adhesive can be wiped away with organic
    solvent (e.g. acetone).
    8. After use and before adhesive hardens mixing and
    dispensing equipment should be cleaned with hot soapy water.
    Shipping:
    Economy shipping method. I can send by registered mail or air mail, ask me for accurate price.
    Delivery time
    14-30 days
    . I usually ship within
    4 business
    days.
    About seller:
    I am responsible seller. It is very important buyer satisfaction.
    Please don't leave negative feedback. Contact if there is problem.